Resource Brochure

Installation Instructions continued..... Side pelmet Adjust Gap 11 While maintaining the tension of the tambour door spring, CAREFULLY unroll the tambour door over the front roller and feed into the aluminium side tracks. The feeder guides on the brackets will point the 1st slat into the track. 7 Using the screws provided, screw fix the top aluminium angle then, using the BLACK screws provided fit your own 1 or 3 piece Pelmet through the aluminium side tracks and the top aluminium extrusion. OR You can align top horizontal section of the Tambortech 3 piece Pelmet Surround to an even gap each side then screw fix aluminium angle to carcass top. Vertical alignment of + or - 1 mm is available on both side & top pelmet sections as shown in drawing. Loosen fixing screws at rear of pelmet - adjust the gaps then re-tighten screws. 4 Fit the 2 part brackets flush to the carcass top and flush to the Blade/Gable front edge using adjustable screw slot [arrowed] first. Ensure the bottom section of the bracket is FIRMLY nested to the top section Ensure the Tambortech Door runs smoothly and freely. Do not leave the door on site if there is an obvious defect. 8 Remove lower section of one of the brackets and place front roller into roller slots. Refix lower section of bracket. Roller must spin freely. 5 Slide the specially designed aluminium angle into position on top of the brackets DO NOT FIX. NOTE:- If Tambortech 3 piece Pelmet Surround has been ordered the TOP Pelmet will be pre-fitted to this angle. 13 Fit the handle & the aluminium backplate. Test for correct tension and, if required, adjust number of turns by removing the handle & backplate and either increase or decrease the number of turns. Re-fix the handle & backplate. 6 Slip the aluminium side tracks onto the locating tab of the brackets. Ensure track is FLUSH with front edge of Blade/Gable then screw fix. NOTE:- If Tambortech 3 piece Pelmet Surround has been ordered, the Side Pelmets will be pre-fitted to the side tracks. Front View Top Pelmet Adjust Tensioning Rotation Direction 9 Unwrap the Tambortech Door, ensuring no dust or particles fall in between the slats, and, from behind the brackets, place the door into the bracket slots. Apply pressure to the pin end to click into bracket .If the cupboard is narrow, remove 1 side of the pelmet surround & track then re-fit when tambour door is in place. 10 Tension the spring by rotating the tambour door in the direction indicated [towards the front] with [ ] full rotations. Tambortech warrant the door against defects and workmanship but only if the door is correctly & competently installed by a certified tradesperson. Brackets are Left or Right handed to accommodate the Tambour Door Feeder Guide . If you wish to screw-fix the TOP of the Pelmet Surround supplied by others, the Pelmet has to be fitted & fixed BEFORE the FRONT ROLLER is fitted. This is why the bracket is supplied in two pieces. 12 Pull the tambour down to the closed position and inspect the tambour door. Are there any gaps or lines in the face of the tambour. If so, there is rubbish between the slats. Un-install the Tambour door, remove the rubbish then re-install. 4 6 5 9 &10 8 7 11 12 &13 Scan the QR code to watch the installation guide video. To scan the QR Code, simply download a free QR or Barcode reader app onto your smart phone.