Resource Brochure

Before Starting... Please read these Instructions carefully. 9 Unwrap the re-wrapped Tambortech Door ensuring no dust or particles enter between the slats and, from behind the Brackets, place the Door into the bracket slots ensuring the wiring to the motor is on the TOP SIDE of the square drive and is pulled through the prepared gable hole. Apply pressure to the pin end to click into the bracket. If the door is too long, temporarily remove the right hand pelmet & track. 11 Connect power lead [supplied] to the motor wiring [molex] at the prepared entry point then connect to power supply. Tambortech warrant the door against defects and workmanship but only if the door is correctly & competently installed by a certified tradesperson. Depending on the size and type of Tambortech Door, there may be more than one package. Ensure the left hand gable has been prepared with wiring entry holes as either Option A, B or C as shown on front page. 1 Carefully unwrap Tambortech Door package. Do not use any kind of blade along the length of the package UNTIL YOU HAVE OPENED EACH END. . 2 All Screws for brackets, handle, pelmet surround & side tracks are supplied in individually marked plastic bags. 3 Using the wrapping, re-wrap the door to protect from possible damage and to exclude dust and particles from collecting between the slats. This is very important - the Tambour will not hang straight if there is rubbish between the slats. metal bracket metal bracket aluminium bracket The Molex and the power lead [dwg 11] must be removable for future maintenance or repairs. Brackets are Left or Right handed to accommodate the Tambour Door Feeder Guide . 4 Fit the 2 part brackets flush to the carcass top and flush to the Blade/Gable front edge using adjustable screw slot [arrowed] first. Ensure the bottom section of the bracket is FIRMLY nested to the top section. The metal bracket fits to the left hand gable. 5 Slide the specially designed aluminium angle into position on top of the brackets DO NOT FIX. NOTE:- If Tambortech 3 piece Pelmet Surround has been ordered the TOP Pelmet will be pre-fitted to this angle. 6 Slip the aluminium side tracks onto the locating tab of the brackets. Ensure track is FLUSH with front edge of Blade/Gable then screw fix. NOTE:- If Tambortech 3 piece Pelmet Surround has been ordered, the Side Pelmets will be pre-fitted to the side tracks. Side pelmet Adjust Gap Front View Top Pelmet Adjust 7 Using the screws provided, screw fix the top aluminium angle then, using the BLACK screws provided fit your own 1 or 3 piece Pelmet through the aluminium side tracks and the top aluminium extrusion. OR You can align top horizontal section of the Tambortech 3 piece Pelmet Surround to an even gap each side then screw fix aluminium angle to carcass top. Vertical alignment of + or - 1 mm is available on both side & top pelmet sections as shown in drawing. Loosen fixing screws at rear of pelmet - adjust then re-tighten screws. metal bracket 8 Remove lower section of the right hand bracket and place front roller into roller slots. Refix lower section of bracket. Roller must spin freely. 10 The Tambortech Door will not turn on the back roller. Carefully feed the tambour over the front roller then into the aluminium side tracks. The bracket feeder guides will assist. There should be 5 slats visible from the top of the side tracks to the bottom of the tambour. IF SIGNIFICANTLY MORE OR LESS THAN THE 5 SLATS - THE INCORRECT FACE OF THE DRIVE SHANK IS IN THE BRACKET SLOT . page 2 of 3 If you wish to screw-fix the TOP of the Pelmet Surround supplied by others, the Pelmet has to be fitted & fixed BEFORE the FRONT ROLLER is fitted. This is why the bracket is supplied in 2 pieces. Molex 5 4 6 7 8 9 10 11