10.Ref cabinet installation instructions.
1 Preparation of the ref cabinet.
Temporally fix some scrap material to the top
of the ref cabinet so that they overhang the
sides. Make sure that you can remove these
later after it is in position. If you cannot
remove the material you will need to fix this
from inside the cabinet.
Tip, Position your screws approximately
50mm from the front and 25mm off the back
to the inside of the cabinet this way if you are
using the bulk head frame you can use the
same screw holes.
2 Positioning of the top cabinet.
Place the top cabinet into position against
adjoining panel, clamp & fix into position
allowing the door thickness margin. This will
give you the position for the other panel.
Tip, You can use two scrap pieces of material
joined together to temporarily prop the
cabinet level whilst you fit the other panel.
3 Fitting the side panel.
Scribe to floor and wall the side panel, then fix
into position as per the panel installation
instructions making sure that you keep the
panel plumb and parallel to the other panel.
Tips, You can fix the side panel to the wall &
floor by simply bedding the panel onto a bead
of construction glue on the floor and wall as
you install the panel.